CrossingTech V5 Atomizer

Divine Crossing V5 Atomizer

The v5 side and bottom heated ceramic cup with vortex airflow can be temperature controlled and is the most effective way to conserve and experience concentrates. Allowing maximum vapor at the lowest temps. You need a box mod with at least 50 Watt and TC Settings to make the V5 Atomizer work.

Settings:

• Wattage 27-37w Pulsing button
• TCR Value 200 using 36w to get to 500°f

Ultimately you will want to practice for the best experience. Some mods put out more power than others at the same settings. To preserve the side and bottom heated ceramic heater cups start on a low setting and work your way up to a happy middle ground of flavor and clouds.

How to Use:

Always keep your orings clean and lubed with a veg oil of your choice. This allows for the top to come on and off easier. Place a small amount (2-5 hits max)of concentrate into the ceramic cup. Keep the unit upright through the whole session, do not tip or concentrate will pour out of the cup. Press button on the mod to start heating the cup, allow concentrates to boil and vapor. Now draw slowly, this will allow for maximum vapor and conserve concentrates in the cup from splashing out. Be sure to maintain heat to cup so vapor is produced throughout the session. Sessions should be no longer than 1 minute.

Cleaning and Maintenance:

Always q-tip the cup right after each session to maintain cleanliness and performance. Wipe down and clean the glass top while warm to avoid reclaim buildup in the pathway of vapor. Allow 3 minutes for the unit to cool down before the next session.

Scope of delivery:

• 1 x V5 diffuser base - now with copper screws
• 1 x Installed Heater
• 1 x Installed Zirconia spacer
• 1 x Windowed airflow cap with vortex airflow and integral heat sink
• 1 x Spare Heater
• 1 x Spare glass tube
• 4 x Spare screws and Allan key
• 2 x Spare o-rings
• 1 x Key-ring Dab tool
• 5 x Q-tips
• 2 x Alcohol pads
• 1 x Instructions (EN only)