Vestratto Tornado Full Rig – High-End CopperCore Convection
The Vestratto Tornado Full Rig features an integrated secondary atomizer that refines vapor into a smoother fog for enhanced bioavailability and gentler draws.
Inside is Vestratto’s patented CopperCore heating system, paired with a medical-grade stainless interior and a magnetic outer body. Heat via torch or the FORGE induction heater.
The TXL chamber is 55% larger than classic XL Bowls, holding around 0.3g depending on grind. Best used with a loose pack for optimal airflow and extraction. Air is regulated by breath or external stem airflow controls.
Includes Tornado Stem and hex-grip TXL Bowl for easy handling. Do not insert threaded bowls into a hot oven to avoid threadlock!
Not compatible with USA or Integrated Stems. Uses standard Anvil screens and O-rings. Limited batch production may lead to minor unit variations.
Highlights:
- Secondary atomizer for refined vapor fog
- Patented CopperCore with stainless steel
- Works with torch or FORGE induction
- Larger chamber (approx. 0.3g) with TXL Bowl
- Includes Tornado Stem
- Only compatible with Tornado components
Included:
- 1 × Tornado Full Rig (with Stem, Oven, TXL Bowl)
Important note on using the TXL Bowl
To prevent the TXL Bowl from binding inside the Vestratto Tornado, the bowl and tip should always be assembled while both parts are cold. A cold start with both parts cold works without any issue. The critical situation is the combination of a cold bowl and a warm or still hot Tornado tip.
Do not insert a cold bowl into an already warm or hot Tornado tip and do not tighten it all the way down until it bottoms out. The reason is simple: copper and stainless steel expand and contract differently when heated and cooled. If a cold bowl is inserted into a hot tip and tightened completely, the bowl may bind as the tip cools down. When the bowl and Tornado heat up and cool down together, this issue usually does not occur.
Recommended use:
Screw the bowl in by hand while everything is cold, then back it off slightly, about 5 degrees. Make sure the airflow holes remain open and that the bowl is not sitting against the bottom of the heating chamber. After use, allow both the Tornado and the bowl to cool down completely before loosening or changing the bowl. This usually takes around 5 minutes.
Tip: To help the Tornado cool down faster, place it on a heat-resistant metal surface, such as a grinder. Do not force the bowl loose while the parts are still hot.
Product safety information
Manufacturer information:
Vestratto
Siehe Verantwortliche Person
, ,
info@vestratto.com
https://vestratto.com/
Responsible person:
VDN Berlin GmbH
Karl-Kunger-Str. 28
Berlin
Berlin, Deutschland, 12435
shop@verdampftnochmal.de
https://verdampftnochmal.de
